1993 DODGE STEALTH 2DR COUPE
Security
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Starter01 BLK/YEL + (+) IGNITION SIWTCH HARNESS
AllDoorTrigger RED/GRN (-) (-) AT CLUSTER PLUG LEFT OF STEERING COLUMN
TrunkTrigger RED/GRN (-) (-) AT TRUNK LIGHT
HoodTrigger BLU/BLK (-) (-) AT ETACS UNDER LEFT DASH
FactoryAlarmDisarm LT.GRN (-) AT ETACS UNDER LEFT DASH
ParkingLights GRN/WHT (+) DRIVER'S KICK PANEL "WHT PLUG"
Remote Start
Battery WHT + (+) IGNITION SWITCH HARNESS
Ignition BLK/WHT (+) IGNITION SWITCH HARNESS
Ignition02 BLU/BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 BLK/YEL + (+) IGNITION SIWTCH HARNESS
AntiTheftSystem NONE
Tach WHT (-) (-) OR BLU/RED(-) AT COIL
SpeedSense YEL/WHT (AC) ECM CENTER CONSOLE, POS 18 OR 66 DRV SID
ParkingLights GRN/WHT (+) DRIVER'S KICK PANEL "WHT PLUG"
BrakeLights GRN (+) AT BRAKE SWITCH
Horn GRN/BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BRN/BLU (-) (-) NEGATIVE TRIGGER
PowerLock BRN/WHT (-) (-) DRIVER'S KICK PANEL AT DOOR LOCK RELAYS
LeftFrontWindow01 LF-GRN/RED
RightFrontWindow01 RF-BRN/YEL, AT SWITCH
LeftRearWindow01 LF-GRN/BLK
RightRearWindow01 RF-GRN/YEL, AT SWITCH
Convenience
HeadLights BLU (+) AT LIGHT SWITCH
Mobile Audio / Video
Battery WHT + (+) IGNITION SWITCH HARNESS
Accessory01 BLU + (+) IGNITION SWITCH HARNESS
Ground -
Illumination GRN/WHT (+) RADIO HARNESS
PowerAntenna WHT/BLK (+) RADIO HARNESS
FrontLeftSpeakerPos WHT/BLU
FrontLeftSpeakerNeg BLK/BLU
FrontRightSpeakerPos WHT/RED
FrontRightSpeakerNeg BLACK/RED
RearLeftSpeakerPos YEL/BLU
RearLeftSpeakerNeg GRY/BLU
RearRightSpeakerPos YEL/RED
RearRightSpeakerNeg GRY/RED
Amp LEFT REAR PANEL
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
